Congratulations!
you have just purchased the most effective and
inexpensive device ever invented to assist in
the coiling of an extension cord. This package
contains two items.
1.
A Hook & Loop ™
Strap to secure the coiled cord.
2.
A Coil-It™ to coil
the extension cord.
Step
1: Install Hook & Loop
Strap
Make a loop in the strap by inserting the plain
end of the strap through the buckle end. Then pull
the loop tight over the cord near the male end.
Leave the strap on the cord.
Step
2: Install Coil-It™
Coil-It™ is a polymer engineered device with
two notched holes, one on either side of the Coil-It™.
Slip the notched hole over the cord about 3 feet
down the cord. Leave it attached. With the cord
and coil-It in one hand, make a coil with the other
hand. Then slip the other notched hole over the
cord near the plug to form your first coil. See
Figure 1.
Step
3: Coil cord
You are now ready to coil. Keeping your hands inside
the coil, begin coiling by pulling the cable towards
you, putting one hand under the other. See Figure
2. Do not try to coil the cord as you would
a rope or lariat. Use this smooth hand under hand
motion, keeping the coils together until you reach
the strap. Upon reaching the strap, you simply wrap
the strap around the coiled cord. Task is complete.
NOTE:
Coil n' Wrap®™ also makes a Coil n' Wrap®™
for your water
hose, TV
Cable and electrical cables in the following
sizes (click any link to view)...
Congratulations!
you have just purchased the most effective and
inexpensive device ever invented to assist in
the coiling of an extension cord. This package
contains two items.